Most photomultiplier applications are satisfied by our standard resitive and active voltage dividers. You will need to consider a custom design if the application places special demands on the divider.
- If a higher than normal current is required.
- If a lower than normal current is required, e.g. if low power consumption is important
- A positive-going signal may be taken off the penultimate dynode. This is in addition to the normal anode signal.
This list is not exhaustive and we welcome a discussion on your particular requirement.
Further information on voltage dividers can be found in our photomultiplier brochure, technical reprint Photomultiplier Voltage Dividers RP/085, which can be obtained by contacting us.
